dummy load การใช้

• Additional accessory kit MK-288 includes adapters and more dummy loads.
• In other equipment, a dummy load is provided when the headphones are not connected.
• Dummy loads will also usually require them.
• The Load setting enables using the Hot Plate as a pure dummy load, with no guitar speaker.
• :: Dummy loads can be very broadband, the shape of the container has little to do with it.
• While at ITER, she designed a 2-MW RF dummy load for Ion Cyclotron Resonant Heater with her partner.
• A "'dummy load "'is a device used to simulate an electrical load, usually for testing purposes.
• Some effects pedals internally produce power-valve distortion, including an optional dummy load for use as a power-valve distortion pedal.
• 3 ) I recall a time when I was transmitting an AM signal into a dummy load and monitoring it with a handheld receiver.
• Veterinarian-grade mineral oil is an inexpensive source for mineral oil and is frequently used by amateur radio operators as coolant in RF dummy loads.
• Proskouriakov was a strong proponent, of the graphical method ( or the dummy load method ) for truss analysis that was based on the theory of influence lines.
• A modular rackmount setup often involves a rackmount preamp, a rackmount valve power amp, and a rackmount dummy load to attenuate the output to desired volume levels.
• He is made to think that he has assassinated the man, though his pistol was actually loaded with tow, a dummy load of heavy, knotted, fibres.
• Size the dummy load so that the converter always has to supply at least 100 mA . & mdash; Bradley 06 : 17, 15 July 2006 ( UTC)
• Pushing a guitar amp to such an extent can destroy components of an amplifier whether using an isolation cabinet, dummy load, power attenuator, or conventional guitar speaker cabinet.
• They refuel with the extra petrol which Morris has taken at the last minute as he " had the wind up " instead of a dummy load of 500 lbs of firebars.
• A very small low-power dummy load such as a ceramic power resistor or 10-watt light bulb can be attached to the supply to allow it to run with no primary load attached.
• Another solution was suggested by Epsley of GEC, who used a tuned circuit of two spark gap tubes and dummy loads to switch off the receiver's input using the magnetron's own signal as the switching signal.
• If an intentional transmitter produces interference, then it should be run into a dummy load; this is a resistor in a screened box or can which will allow the transmitter to generate radio signals without sending them to the antenna.
• If the current being drawn from the 12V output to ground is less than this additional current you are injecting into the output then the output voltage will rise above 12V . You could put a dummy load on the 12V to ensure regulation.